DEWATERING FEEDERS
900 x 1400 mm dewatering
feeders driven by two
overhead mounted vibratory
motors and using
polyurethane drainage panels.
Star Trace Dewatering Feeders are designed to fulfill two basic
requirments; remove the excess moisture and regulate the feedrate of the
processing equipment.
Head feed to mineral processing equipments often contains excessive moisture adversely affecting the performance of such equipment.
Polyurthane or stainless steel wedge wire screen panels on the feeder
pan allow the water to pass through, drying the solids in the feed.
The vibratory motors can either be mounted below and to the rear
of the pan, or overhead. Overhead mounting allows maximum area of drainage
panel.
Units range in size from 300 x 900 mm to 1200 x 2500 mm, and can
be floor mounted or suspented. The feedrate can be varied by altering
the out-of-balance weight settings on the vibratory motors, or by remotely
controlling the speed of the motors through a frequency convertor unit.
450 x 2650 mm dewatering feeders driven by two underslung vibratory
motors, and using a wedge wire drainage panel. Liners are HDPE.
