Chute-Rotary Magnets
Electro Magnetic Vibrating Chute
These are high powered Electro Magnetic Vibration Chute Separator
mostly used for treating fine and dry materials where iron could not be
extracted by other Magnetic separators and need a very fine Magnetic feed
for free flow where iron percentage is not more than 2%. This is complete
with Structure, Hopper, Vibrating
This is complete with Structure, Hopper, Vibrating Tray with feed regulation
and Cascade type Magnetic Pole Plates having peak Magnetic field on the
Top of Pole and under each pole there is a pocket into which iron particules
are drawn and these separators are capable to extract even the finest
iron particles as they pass over a series of Magnetic Poles of Alternate
field.
The materials are feed by hopper and an Electro Magnetic Vibrating
Tray carries it and discharges over the Magnetic Cascade Poles where materials
fall down leaving behind the iron particies trapped in the pole pocket.
The Delivery end is equipped with collapsible bridge which shuts off when
current fails and avoid mixing of materials.
Electro Magnetic Vibrating Chute
Rotary Motorised Magnetic Grids has SS Magnet Tubes on a circular arrangement
held in place by two stainless steel end plates, a Speed Reduction Gear
Motor and Starter. This is ideal for material that do not flow easily
and obstruct flow in plain Grid.
Rotary Grid is recommended for Sticky Diary products, pulverized minerals
and ceramics, fibrous substances, Lino and fine cohesive materials such
as magnesium oxide, zircon powder, fly ash,. alumina, gypsum, lime, powder
sugar, cornstarch and flour. The rotary action not only prevents materials
from briding, but it improves magnetic separation by agitaing cohesive
powders.
It is manufactured as independent unit with Rare Earth Ndfeb Magnets
in 25 mm Dia Tube. These are manufactured with manual and easy clean design.
Sizes manufactured 300 x 300mm - 15 M3/hr. 400 x 400mm - 25 M3/hr.