Water is the most commonly used media for cooling, be it internal combustion engine, compressors, furnaces, Air conditioners etc. the reason being it absorbs maximum heat per cubic centimeter and does not become a hazard. Oil and other liquids carry much less heat and are fire hazards too. Water, as obtained naturally, has one major problem i.e. tendency to form scales on the pipes or other areas in which it is circulation especially when hot.

This scale formation results in:

1. Chocking of passage resulting in less flow and consequently consumption of more energy

2. Non-Conducting layer being formed between heat source and water, which is taking away that heat, thus reducing efficiency of cooling. This can be eliminated by using water softening plants which are cumbersome, difficult to operate, incur recurring costs and can not be utilized in all cases due to paucity of space. However all these problems can be solved! Thanks to the revolutionary technology of treating water which is no available!!

Magnetic Anti Scale Unit

• It requires No chemicals, No salts, No energy, No backwashing

• Easy to Install

• Just connect directly to the main water supply.

• Does Not Affect

• The quality or taste of the water

It Works By

It is based on a process which treats water without altering its mineral composition. Water flows through a magnetic coil from highly efficient permanent magnets. In this cell the water crosses a magnetic field perpendicular to the lines of induction. This contact polarizes the molecules contained in the water, thereby disrupting the normal crystallization process of mineral salts such as calcium and magnesium. Once these salts have been physically modified in this way, they lose their ability to attach themselves to the lining of pipes and tanks.

Operating Principle

Molecules (CaCo3, Potassium, Manganese, etc.) which are in natural suspension in water, tend to form macro molecules which, if nothing is done, continue to coagulate, causing scale to collect in the pipes with resultant reduction in flow and increased consumption of energy.

Technical Principles

Permanent magnets are installed along the entire length of the appliance, the lines of magnetic flux being captured by a mild iron cylinder (care being taken that the flow-rate is not affected.)

What Is The Result?

When passing through the magnetic field, the macro-molecules are polarized in such a way that their conglomerate structure is deliberately disorganized so that their original molecular state of natural suspension in the water is re-established. After passing through this induced field, they will retain a residual magnetic charge for more than 30 hours (which is substantially longer than the water renewal cycle, which does not exceed 12 hours); they cannot therefore recoagulate. In the case of ferruginous water, ferrous and ferric welding residues, an anti-corrosion process is established (thus eliminating electrolysis phenomena.)